PDA

View Full Version : Rebuilt 1996 CBR600F3

racer51
04-19-2010, 11:39 AM
I've given the "old rust bucket" back her dignity:

Before:

http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/before.jpg

http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/DSC01898.jpg
http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/CBR600F3-right-side-SMALL.jpg
http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/CBR600F3-right-front-swirl-.jpg
http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/CBR600F3-rear-left-upper-sw.jpg
http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/CBR600F3-rear-SMALL.jpg
http://i168.photobucket.com/albums/u180/edmontonmotorcycle/motorcycles-Scrapblog/F3-rebuild-project/CBR600F3-front-left-swirl.jpg
Juan42
04-19-2010, 12:25 PM
The ugly duckling has been transformed...WoW. That does look awfully cool. Nice work Rick !
racer51
04-19-2010, 01:19 PM
Hi, Everyone.

Can anyone suggest a good way to fill the space under the tail-piece? Plastic and zip ties?
Backmarker
04-19-2010, 07:17 PM
Nice job Rick, does this mean you will be racing it this year? If you wanted to fab a sheet of fiberglass to use as filler, I reccomend doing some fiberglass mat on a sheet of that white aborite or something similar as the resin will not bond with it then cut/paint and zip tie to fit. My 2 pennies.
racer51
04-21-2010, 11:03 AM
Nice job Rick, does this mean you will be racing it this year? If you wanted to fab a sheet of fiberglass to use as filler, I reccomend doing some fiberglass mat on a sheet of that white aborite or something similar as the resin will not bond with it then cut/paint and zip tie to fit. My 2 pennies.

Thanks Kent. I'll try your suggestion.
YZF1000jon
04-21-2010, 07:02 PM
Black duct tape!