Cbr600rider2
Member
Here is a 2010 CBR1000 Racebike
I will probably miss a few things with the bike so your more than welcome to msg me about it later
* This bike was torn down with engine out and rebuilt with all new gaskets and seals aswell as high compression pistons and minor porting ( 2015)
* Has been a race bike for 3 seasons and currently on slicks and running a 123.7 at Castrol raceway
* This bike has been well maintained with an oil change every second round
- It is ready to pass tech and will do so with no issues
starting from the front:
-Galfer waved rotors with cp1 race pads
- Dunlop slicks
- block off plates with clean air mod
- stainless lines front and rear
- armour bodies bodywork with superbike tail - painted professionally
- ohlins valved forks
- vortex case cover n woodcraft saver on other side
- frame sliders
- fuel tank foam
- swingarm spools
-vortex rearsets - a few spares
- aftermarket airfilter
- Full bazzaz ZFI-TC -QS programmer with shift light and traction control light on dash and map selector, comes with regular shift bazzaz quick shifter
-rear suspension is stock and all suspension is set for 210lb rider with gear
-fully safety wired
-520 chain and sprocket conversion
theres more but my brain is starting to hurt
I can also remove a few aftermarket parts ( put on stock ) to lower the price a little if interested
ASKING $5500 OBO if your am EMRA member we can work out a better deal !
PS: Yamahas are slow
I will probably miss a few things with the bike so your more than welcome to msg me about it later
* This bike was torn down with engine out and rebuilt with all new gaskets and seals aswell as high compression pistons and minor porting ( 2015)
* Has been a race bike for 3 seasons and currently on slicks and running a 123.7 at Castrol raceway
* This bike has been well maintained with an oil change every second round
- It is ready to pass tech and will do so with no issues
starting from the front:
-Galfer waved rotors with cp1 race pads
- Dunlop slicks
- block off plates with clean air mod
- stainless lines front and rear
- armour bodies bodywork with superbike tail - painted professionally
- ohlins valved forks
- vortex case cover n woodcraft saver on other side
- frame sliders
- fuel tank foam
- swingarm spools
-vortex rearsets - a few spares
- aftermarket airfilter
- Full bazzaz ZFI-TC -QS programmer with shift light and traction control light on dash and map selector, comes with regular shift bazzaz quick shifter
-rear suspension is stock and all suspension is set for 210lb rider with gear
-fully safety wired
-520 chain and sprocket conversion
theres more but my brain is starting to hurt
I can also remove a few aftermarket parts ( put on stock ) to lower the price a little if interested
ASKING $5500 OBO if your am EMRA member we can work out a better deal !
PS: Yamahas are slow
Attachments
Last edited: