cbr600rr - 2013 tail on a 2007

blam

Administrator
apparently, it can be done, but I'm not seeing how.

can anyone with experience give me a couple pointers?

any help would be appreciated! thanks!



 
Last edited:
i know a lot of the tails have to be pulled wide to stretch over the tail section on those OR start at the back and slide them forward ? a lot of the 600 you really have to stretch the fairing wide and press down
 

blam

Administrator
i know a lot of the tails have to be pulled wide to stretch over the tail section on those OR start at the back and slide them forward ? a lot of the 600 you really have to stretch the fairing wide and press down

thanks, ill give that a try and report back.
 

blam

Administrator
well, that was embarassingly simple... i just went out, warmed it up with my propane heater and popped it on....

hopoefully it matches up well with the other pieces

thanks again!
 

SetUpSixRR

EMRA Executive Member
You shouldn't even have to warm it up! Just pull on it a little haha
Oh and you may have to cut the tip off the battery tray.
 

blam

Administrator
You shouldn't even have to warm it up! Just pull on it a little haha
Oh and you may have to cut the tip off the battery tray.

yeah, I noticed, the tail sits a bit rearward of where it would attach to the tank.

looks like i might need to trim about 1/2" off

are there other modifications to fit the 2013 body work? I'm having a hell of a time lining up the other stuff. everything is like 1/2" out here and there.

thanks brian!
 
Top