Fabrication services and broken race bits repair.

[electrobiker86]

Hi Ryan, not really bike related but...
I would like to have trays built 1.5 inches deep to place under my washing machines, one is roughly 25" square the other roughly 30 "square. What would that cost roughly? Stainless I guess would be the best material, but open to suggestion.

 

[sand.man]

Hi Ryan, not really bike related but...
I would like to have trays built 1.5 inches deep to place under my washing machines, one is roughly 25" square the other roughly 30 "square. What would that cost roughly? Stainless I guess would be the best material, but open to suggestion.

Apologies David, I didn't get any alerts about your post.

To clarify, 2 trays total. 1 @ ~25x25" 1 @ ~30x30" ?

 

[electrobiker86]

Apologies David, I didn't get any alerts about your post.

To clarify, 2 trays total. 1 @ ~25x25" 1 @ ~30x30" ?

No worries, I would have to measure the appliances to double check but yes that is correct on quantity and rough size, is that adequate for an estimate? I think if anything the 30 x 30 may have to be a touch smaller, I will measure them tonight.

 

[RamboRay]

Sand.man,

What is your email address? I can't find it on here any where.
I need a new bracket welded onto my titanium exhaust can.

Kind regards,

Ray