Dayton
New Member
!Engine does not work!
I am either looking for a new engine for me to race this bike again, or I want to sell it and move up to middleweight for 2026.
Parts list:
•Spare frame
•Rear section has been cut off behind the seat on current frame, may need to make a small bracket to hold the tail up depending on which tail you go with. Works fine with the current tail
•Woodcraft dual temp tire warmers
•Spears racing front brake guard
•Vortex clutch and brake levers
•Shorai battery
•Motoholders fairing stay
•Motion Pro Quick turn throttle
•Motion Pro kill switch
•Key delete
•R&G Racing case covers
•Woodcraft rear sets
•415 chain/sprockets
•Vortex clip ons
•Race carbon front pads
•EBC front rotor
•Ohlins linear steering damper
•Fork brace
•Ktech fork cartridges done by Vass (4 weekends on them)
•Currently sprung for 185 lbs rider (Plus gear)
•JRI Remote reservoir custom Vass built/valved shock w/extended clevis and link bars to Willie's spec
•315cc Spears Racing big bore and high comp piston (Runs on pump gas)
•Spears Racing cams
•Spears Racing ECU tune
•PC5
•K&N filter
•Spears racing velocity stacks
•Full Hindle Evo SS Supersport exhaust
•Spears Racing Shift detent arm/spring
•Bike weighs about 305 lbs race weight
•Lightweight aluminum Marchesini wheels (2 weekends on them, never crashed)
•Aluminum triple clamp with 43mm offset (Vass spec)
•Parts that come with it:
•Current wheels have 2-year-old slicks on them but have always been in heated storage. They were used in only one race. •Spare set of wheels with used rains – captive wheel spacers •Front and rear bike stands
•I have all sorts of extra parts in a bin for the 300 that will go with it. (front brakes, chains, fuel pump, etc.)