Finished my last cylinder head...for a few years anyways so up for sale is my seat grinder. If anyone is doing engine work for you and they are not re-machining the valve seats you are only getting half a job and less power...if they are using hand cutters id rather they just didn't.
$4750 obo
Peg orbital valve seat grinder made in Italy. The stone orbits the pilot by 1mm to cut a perfectly concentric seat with no chatter. Much better finished seat than hand cutters at a fraction of the cost of a full sized Serdi or Sunnin. Any stone/seat angles are possible with the stone dressing tool included. 3 angle, 5 angle, 7 angle seats are simple to produce.
Go to the manufacturer’s website below for details.
http://www.pegrk.com/e/8avio/peg8avio.html
Re-machine to perfection valve seats on any inline four, triple, v-twin, single cylinder etc. four stroke cylinder heads with the very rigid full sized cylinder head leveling bar.
Comes with:
-60 stones of varying grits and sized
-two 4mm solid carbide pilot
-two 4.5mm pilot
-2 solid carbide 5mm pilot ***every size needed for any motorcycle***
-two 5.5mm solid carbide pilot
-two 6mm pilot, two 6.5mm pilot
-two 7mm pilot, two 8mm pilot
-one 11/32” pilot
-billet aluminum cylinder head levelling bar
-all pilot wrenches and tools
-adjustment and levelling tools
-hard transport case
-manual
Over $6500 for everything new out of Italy. One owner.
$4750 obo
Peg orbital valve seat grinder made in Italy. The stone orbits the pilot by 1mm to cut a perfectly concentric seat with no chatter. Much better finished seat than hand cutters at a fraction of the cost of a full sized Serdi or Sunnin. Any stone/seat angles are possible with the stone dressing tool included. 3 angle, 5 angle, 7 angle seats are simple to produce.
Go to the manufacturer’s website below for details.
http://www.pegrk.com/e/8avio/peg8avio.html
Re-machine to perfection valve seats on any inline four, triple, v-twin, single cylinder etc. four stroke cylinder heads with the very rigid full sized cylinder head leveling bar.
Comes with:
-60 stones of varying grits and sized
-two 4mm solid carbide pilot
-two 4.5mm pilot
-2 solid carbide 5mm pilot ***every size needed for any motorcycle***
-two 5.5mm solid carbide pilot
-two 6mm pilot, two 6.5mm pilot
-two 7mm pilot, two 8mm pilot
-one 11/32” pilot
-billet aluminum cylinder head levelling bar
-all pilot wrenches and tools
-adjustment and levelling tools
-hard transport case
-manual
Over $6500 for everything new out of Italy. One owner.
